Strands S68 Drill Press Manual

Bolt the base securely to the floor using heavy-duty masonry anchors.

The is a "pelarborrmaskin" (pillar drilling machine) known for its robust geared head design. Unlike belt-driven drills that can slip under heavy loads, the S68's geared head provides consistent torque and a wide range of precision speeds.

The S68 uses a combination of sealed bearings and oil-bath components. The manual specifies:

Lubrication should be done via the three oil nipples located on top of the motor unit and two on the table crank mechanisms. Strands S68 Drill Press Manual

8 geared speeds, ranging from 100 to 2900 RPM. Quill Travel: 140mm (approximately 5.5 inches). Motor: 1.1 kW (typically 3-phase, 415-volt). Throat Depth: 250mm from spindle center to column. Weight: Approximately 200 kg. Origin: Made in Sweden. Highlights of the Strands S68 Manual

The Strands S68 standard configuration requires a 3-phase power supply (typically 230V or 460V).

Typically features 4 to 8 mechanical speeds, selectable via dual gear levers on the headstock. Bolt the base securely to the floor using

Do you need assistance identifying the exact or a replacement parts list? Share public link

The defining feature of the Strands S68 is its mechanical gearbox. The machine typically offers 8 distinct spindle speeds, achieved through a combination of mechanical gear levers and a two-speed electrical switch. How to Shift Gears Safely

Toggles the pole-changing motor between Low (I) and High (II) speeds. Feed Mechanisms The S68 uses a combination of sealed bearings

Note: Some parts, particularly internal gear components for older models, may be listed as "UTGÅTT/NOT AVAILABLE" or "discontinued", making it necessary to work with specialist refurbishers. 3. Key Operational Procedures Setting Speeds

Loosen the clamp handle on the column and use the crank handle.

Change the oil after the first 50 hours of operation for a newly reconditioned machine, and every 1,000 operating hours (or annually) thereafter.