Skope Heated Towel Rail Timer Instructions !link! [Confirmed - 2026]

Press the MANUAL button to shift the arrow from AUTO to ON . The rail will heat indefinitely until you switch it back.

Usually operates at a lower wattage or for shorter, optimized bursts to save energy. Troubleshooting the Skope Timer

: When first turned on, the rail automatically follows a "Pre-set function": it stays ON for 4 hours , followed by 8 hours OFF .

Use the + / - (or Up/Down) buttons to select the current day (MTWTFSS). skope heated towel rail timer instructions

Most models allow you to set specific ON/OFF times, often featuring multiple daily programs.

Keep your Skope heated towel rail warm and ready when you need it. This short guide explains the common timer functions and simple steps to set and use the timer so towels are warm at the right times while saving energy.

: On the first day of use, press the button at the exact time you want the rail to start (e.g., 7:00 AM). It will then remember this time and run for its factory-set duration (usually 1 hour) every day at that time. Press the MANUAL button to shift the arrow from AUTO to ON

Ensure the controller is set to Timer or Auto mode, not manual or off. Common Operating Modes Explained

Ensure the controller is set to "Auto" or "Timer" mode, not just "Manual" or "Off".

Quick Tip: You can press and hold down the advance arrow keys for rapid data adjustments when dialing through the 60-minute cycle parameters. 5. Engaging the 2-Hour Quick Boost Function Troubleshooting the Skope Timer : When first turned

For specific wiring diagrams or replacement parts, contact Skope customer support directly with your model number located on the back of the rail’s mounting bracket.

: Press the Timer (or PG) button once until "1 ON" appears. Set the desired start time using the Hour and Min buttons.

Heated Towel Racks with Timers - Bathroom Butler United States

Click the to save your selection and initiate the preferred operating mode. 3. Programming In-Wall Sequential Timers (GBT Modules)

Turn the unit off at the wall or switch for at least 60 seconds , then turn it back on.