Sinotimer Tm-630s Manual -

The Sinotimer TM-630S is a 7-day digital programmable timer switch capable of managing high-current loads up to 30A. It features 1-second setting intervals and a low-power CMOS chip for high accuracy. Capacity: 30A Resistive. Timing Range: 1 second to 168 hours. Programs: Up to 28 ON/OFF settings per day.

Before creating schedules, you must set the correct clock time.

⚠️ Electrical installation must be handled exclusively by a licensed electrician. Ensure the master circuit breaker is completely powered down before stripping or connecting wires.

However, like many multi-function digital timers, the TM-630S can be intimidating at first glance. The button labels are small, the instructions (often printed on a single folded sheet) are frequently lost, and the "manual" is not always easy to decipher. sinotimer tm-630s manual

Pressing the button toggles the active state displayed at the bottom of the LCD matrix:

Sinotimer TM-630S User Manual: The Complete Setup and Programming Guide

Set the time you want the device to turn OFF using , H+ , and M+ . Repeat for programs 2–16 if necessary. Press CLOCK to save and exit. 4. Manual Override Modes Press the MANUAL button to cycle through three modes: ON: The output is permanently ON. AUTO: The timer follows your programmed schedule. OFF: The output is permanently OFF. Safety and Installation The Sinotimer TM-630S is a 7-day digital programmable

: Cancels/recalls an active setting, and acts as the interface lock button.

Press the Reset button (usually a small hole marked 'R' or 'C') using a pin before the first use to clear all memory. 3. Setting the Current Time (Clock Setup) Hold Down the "Clock" (C/R or Timer) button . While holding Clock , press D+ (Day) to set the correct day. While holding Clock , press H+ (Hour) to set the hour. While holding Clock , press M+ (Minute) to set the minutes. Release the Clock button. 4. Programming the Timer (ON/OFF Times)

:

Internal battery keeps settings for up to 90 days during blackouts. Step-by-Step Programming Guide 1. Unlock the Device The device often auto-locks to prevent accidental changes. Action: Press the C/R (Cancel/Recall) button 4 times .

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.