Lenel Lnl3300m5 Installation Manual Upd Top

Power down the legacy CASI controller and unplug all field wiring from the existing legacy boards.

: Connect the LNL-3300-M5 to a computer via the onboard Ethernet port. Configure the computer’s IP address within the 192.168.0.x range (e.g., 192.168.0.2 ), avoiding 192.168.0.251 , which is the default for the controller. Access Web Page

Ensure the downstream RS-485 configuration switches match the target controller profile. Apply primary DC power to the panel. Launch the interface. Navigate to Access Control > Hardware configurations.

: Line up the board holes with the original factory standoffs inside the enclosure. Hand-tighten the screws to avoid cracking the multi-layer printed circuit board (PCB). Step 2: Wiring Power and System Inputs

Verify network cable continuity and confirm the switch port is active. To help finalize your system configuration, tell me: lenel lnl3300m5 installation manual upd top

Replaces CASI M5/M3000 CPUs (E, P, PX, PXN, PXNplus) and CASI Power/Comm Boards. Installation Steps Preparation:

Internal 120-ohm termination resistor engaged (End of line). SW 8 OFF: Termination disengaged (Pass-through node). 📊 Status Indicators (LED Diagnostics)

Download the new configuration database to the panel and monitor the communication status LED for verification.

If converting to the Lenel M Series, all boards in the controller must be replaced; legacy CASI boards cannot be mixed with Lenel M Series boards. Initial Configuration & IP Setup To access the web configuration page for initial setup: Set Computer IP: Change your computer’s IP address to a range between 192.168.0.2 192.168.0.254 (excluding 192.168.0.251 Hardware Toggle: Set the board’s DIP switches: Switch 3 & 4: Power down the legacy CASI controller and unplug

Whether you are installing a new LNL‑3300‑M5 for the first time or performing routine maintenance on an existing system, this guide provides the essential procedures needed to keep your OnGuard access control system running reliably for years to come.

Insert the LNL-3300-M5 into the same slot on the M5/M3000 backplane. It is designed to be physically compatible with the existing footprint.

The Lenel LNL-3300-M5 Go to product viewer dialog for this item.

Sets the cardholder capacity/database layout allocation mode. Network Configuration and Initialization Access Web Page Ensure the downstream RS-485 configuration

All wiring must comply with National Electrical Codes (NEC) as well as local jurisdictional regulations. 1. Power Supply Wiring (TB1) Connect a clean, filtered 12–24 VDC power source to TB1. VIN (+ VDC) TB1-2: GND (0 VDC) 2. Downstream RS-485 Communication (TB1)

Lenel LNL-3300-M5 Installation Guide: Upgrade & Setup The Lenel Intelligent System Controller (ISC) LNL-3300-M5 is an advanced access control panel designed to replace legacy CasI-Rusco Micro/5 panels. This drop-in solution allows facilities to upgrade to the OnGuard system without rewiring existing enclosures.

Set to activate the default credentials: Username admin / Password password .