Ge Timer Switch 532641l3 Instruction Manual Pdf Pdf Install

How to Program GE 5326-41L3 for Dusk to Dawn Control – FAQ 2 Feb 2024 —

Press the Clock or Set button once more to lock in the time. Programming Custom ON/OFF Schedules

Attach the red timer wire to the light fixture wire.

Once power is restored, it will take about 1 minute for the timer to fully charge. The load may turn on, but it will automatically shut off after the charging cycle. 3. Operation and Troubleshooting

Tip: Secure each wire nut tightly and wrap them with a bit of electrical tape for added security. Ensure no bare wire (except the ground) is exposed. Step 5: Mount the Switch ge timer switch 532641l3 instruction manual pdf pdf install

| Parameter | Rating | |-----------|--------| | Voltage | 120–277 VAC, 60 Hz | | Resistive load | 40 A (240 VAC) | | Tungsten / Ballast | 10 A @ 120 VAC | | Motor (HP) | 2 HP @ 120/240 VAC | | Timer mechanism | Synchronous motor (24-hour dial) | | Minimum ON/OFF time | 30 minutes (using two trippers) |

Connect to the Neutral (white) bundle in the box.

By providing a comprehensive overview of the GE Timer Switch 532641L3 instruction manual PDF, users can easily install, program, and operate the device to enjoy its features and benefits.

This guide serves as an all-inclusive manual for installing, wiring, and programming your GE timer switch. Technical Specifications and Safety Precautions How to Program GE 5326-41L3 for Dusk to

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Use the and Min buttons to adjust the display to the current time. Pay close attention to the AM/PM indicator on the screen.

Adjust the arrows until your desired countdown time appears on the screen.

Verify the power is off using a non-contact voltage tester at the switch box. The load may turn on, but it will

| Terminal | Connection | |----------|-------------| | L1 (Line) | Hot wire from power source – Phase A (Black) | | L2 (Line) | Hot wire from power source – Phase B (Red) | | T1 (Load) | To Load – Phase A (Black) | | T2 (Load) | To Load – Phase B (Red) | | Ground | Green or bare copper wire to grounding screw |

Note: If the screen is blank after turning on the power, you may need to press the small button (often a tiny recessed button near the bottom) using a toothpick or paperclip to initialize the system. 1. Setting the Current Time and Day

Disconnect the wires from the old switch. Label each wire (Line, Load, Neutral, Ground) as you remove them to avoid confusion during the re-wiring process. Step 3: Wire the GE Timer Switch