Opcom 1.99 Drivers Windows — 10

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

It is often listed under "Other devices" or "Universal Serial Bus controllers." 📂 Step 3: Manually Update Drivers Right-click the device and select Update driver "Browse my computer for drivers."

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Because OP-COM firmware version 1.99 uses counterfeit or older FTDI chips, Windows 10 automatically blocks the installation due to driver enforcement policies. This comprehensive guide will walk you through the exact steps required to bypass these restrictions and successfully install the OP-COM 1.99 drivers on Windows 10. Step 1: Download the Correct Driver Package opcom 1.99 drivers windows 10

Your computer will boot into a temporary mode that allows the installation of third-party clone drivers. Step 2: Download the Correct OP-COM 1.99 Driver Package

Alternatively, navigate through system settings: Go to > Update & Security > Recovery . Under Advanced startup , click Restart now .

Windows will complete the installation. The device name in Device Manager will shift under "Universal Serial Bus controllers" as . This public link is valid for 7 days

Download the correct driver (choose one based on chipset)

– it’s not an official product from Bosch or General Motors. The “1.99” firmware is widely used with cracked copies of Opcom software (often v120 or similar). Because of this, official drivers do not exist, and getting it working on Windows 10 involves workarounds.

Note the exact folder path where you extracted the files (look for a folder named Drivers or FTDI_Drivers ). Step 3: Install the OP-COM Driver via Device Manager Can’t copy the link right now

Click and navigate to the driver folder you extracted to your Desktop in Step 2.

Some versions of the OP-COM software communicate via a virtual serial link rather than direct USB commands. Open and expand Ports (COM & LPT) . Right-click USB Serial Port and select Properties . Go to the Port Settings tab and click Advanced .

Check the box for and optionally set the compatibility mode to Windows 7 . Click Apply and OK . Launch the software.