Adjustment Program Reset Epson R290 |verified| -

The Reset Program will not work if the printer is in normal mode. You must manually force the printer into a special state.

Remember: Always reset both the Main and Platen counters. Always back up your printer’s EEPROM data if the program offers a "Backup" button (usually under "Initial settings" but use extreme caution). And never run an "Initial Ink Charge" unless your waste ink is physically routed to an external bottle.

This error is a hardware failure in the traditional sense. Instead, it is a pre-programmed counter that tracks how much ink has been flushed into the printer’s internal waste ink pads. Once that counter hits a specific number (usually around 15,000 to 20,000 pages), the printer locks down completely. You cannot print, scan (if applicable), or even move the print head.

: Check the box for "Main pad counter" and click the "Check" button to see the current usage percentage. adjustment program reset epson r290

Connect your Epson R290 directly to your computer using a standard USB cable. (Do not use a Wi-Fi connection or a USB hub). Turn the printer on.

This paper is for informational purposes only. The use of service mode software can void manufacturer warranties and carries a risk of hardware malfunction if performed incorrectly. Always adhere to local environmental regulations regarding the disposal of ink-saturated materials.

In the new window, scroll down the list until you find "Waste ink pad counter" . Select it and click "OK" . The Reset Program will not work if the

The printer uses a digital counter to estimate when these pads are full. Once this counter hits 100%, the printer locks down to prevent ink from overflowing onto your desk.

Temporarily disable your antivirus or Windows real-time protection, as these programs are often flagged as false positives.

Disclaimer: This article is for educational purposes. Modifying your printer's firmware may void any remaining warranty. Always back up your system and create a restore point before running third-party adjustment tools. Always back up your printer’s EEPROM data if

When the printer estimates these pads are full (usually after 1–3 years of heavy use), it triggers a error or flashing lights (often the two red LEDs alternating) and locks up completely. The Adjustment Program is a third-party software tool that resets this counter to zero.

You have three options:

The (often referred to by technicians as the Epson Resetter) is a specialized utility software tool. Epson service centers originally designed this program for maintenance and calibration.