Avoids crosstalk when two sensors face each other. (High / Low) Radar Directionality
ProSecure Opti Combi Manual: Installation, Programming, and Troubleshooting Guide
After installation, the sensor requires a "learning time" (typically ~60 seconds) to map the static environment.
Wait for the auto-setup routine to finish. Do not walk nearby. Door reflection error prosecure opti combi manual english
The ProSecure Opti Combi is a high-performance, dual-technology sensor widely used for automatic doors. It combines radar technology for motion detection (activation) with active infrared technology for presence detection (safety). This comprehensive English manual provides step-by-step instructions for installing, wiring, programming, and troubleshooting your ProSecure Opti Combi sensor to ensure maximum safety and efficiency. 1. Technical Specifications
Once powered on, you must configure the detection fields to match your specific entryway dimensions. Radar Motion Field Adjustments
If you need help finding the specific, full-length for your ProSecure Opti Combi, I can try to help you search for it. To help you troubleshoot or install, could you tell me: Are you getting any specific error codes ? Avoids crosstalk when two sensors face each other
The ProSecure Opti Combi features built-in programming keys and an LED status indicator display. Configuration can be performed via on-board buttons or an optional infrared remote control. Programming Using On-Board Buttons
Note: Some industrial variations include additional blue or black wires dedicated to external monitoring test inputs required by local safety codes (such as EN 16005). 4. Dip Switch Programming and Field Adjustments
Adjust the rows of infrared spots to ensure they cover the threshold of the door. Do not walk nearby
Use the internal plastic shutters or specific dip-switches to mask outer infrared beams if the doorway is narrow. Dip-Switch Configuration
[ Sensor Body ] <-- Mount centered above the door header / | \ / | \ / | \ / | \ [Radar] [IR Curtain] [Radar] (Motion) (Safety Zone) (Motion) Step 1: Preparation Turn off all power going to the automatic door operator.
*Note: The safety output configuration (Normally Open or Normally Closed) can be adjusted via the internal DIP switches based on your specific door controller requirements. 4. Mechanical and Electronic Adjustments
Options include 10s, 30s, 60s, 180s, or 15 minutes. Environmental Considerations
Carefully remove the cover, ensuring not to damage the internal electronics.