Press and hold the or Volume Up key (this triggers the bootrom mode on various models).
Re-install the MTK VCOM drivers and try a different USB port.
Reinstall the MTK VCOM drivers. Ensure you run the application with administrator privileges and temporarily disable your antivirus software. BROM Error: S_CHIP_TYPE_NOT_MATCH (3168)
SP Flash Tool v5.1480: Download and Setup Guide SP Flash Tool
Connect the device to the PC via the USB cable while holding the volume key. 4. Monitor Progress sp flash tool v480 download link
Yes, there are Linux and macOS versions available, but they are not as widely supported as the Windows version. For a trouble-free experience, using a Windows PC is highly recommended.
| Component | Requirement | |-----------|-------------| | Operating System | Windows 7, 8, 10, or 11 (32-bit or 64-bit) | | CPU | Intel Core i3 or equivalent | | RAM | 2 GB minimum (4 GB recommended) | | Storage | 1 GB free space | | Additional | MediaTek USB VCOM drivers |
Smart Phone Flash Tool (SP Flash Tool) is the definitive software application for flashing custom ROMs, stock firmware, and custom recoveries on MediaTek (MTK) Android devices. If you are looking for the specific , this comprehensive guide provides secure access to the software, step-by-step installation instructions, and troubleshooting steps to revive or upgrade your smartphone. 1. SP Flash Tool v4.80 Download Links
For authentication-protected newer MediaTek devices, you may need to use a bypass tool or set custom connection settings: go to Settings → Connection tab and configure UART connection mode with COM port and baud rate (often 921600). Press and hold the or Volume Up key
Extract both the downloaded SP Flash Tool v4.80 zip file and your stock firmware zip file into separate folders on your desktop for easy access. Step 2: Launch the Executable
To assist you further with your device recovery, let me know: What is the exact of your MediaTek device?
This comprehensive guide provides everything you need to know about downloading, installing, and using SP Flash Tool version 4.80 safely. Direct Download Links for SP Flash Tool v4.80
Change the USB cable. Connect to a rear USB 2.0 port on your PC instead of a USB 3.0 (blue) port. Reinstall the MediaTek VCOM drivers. To help find the right resources, please let me know: Ensure you run the application with administrator privileges
: Essential for your PC to communicate with your device in "Preloader" mode.
. Avoid "patched" or "bypass" versions that claim to disable security checks, and do not trust versions bundled with cracked tools or modified installers.
What is your (e.g., MT6580, MT6737)? Are you unbricking or just upgrading ? Let me know so I can help you find the correct solution.
This usually points to an incorrect firmware file or a faulty USB connection. Reinstall the VCOM drivers or try a different USB port (preferably a USB 2.0 port on the back of the PC motherboard).