Simco Fmx002 | Manual Top

The unit uses a 9V battery. If the "BATT" icon appears, replace it immediately, as low voltage will lead to inaccurate readings.

: Two LED "guide rings" converge into a concentric circle when the meter is held at the correct 25mm (1 inch) distance from the target surface.

The oscillating chopper sensor at the top of the meter is highly sensitive.

9V manganese battery (approximately 30 hours of continuous operation). simco fmx002 manual top

Turn off immediately. Clean with compressed air or send for service. Battery voltage is low Replace the 9V battery immediately to maintain accuracy. Inconsistent distance readings LED range guides are misaligned

Complete Guide to the Simco FMX-002 Electrostatic Fieldmeter

This is the most critical step. Static meters measure the potential difference between the sensor and ground. The unit uses a 9V battery

Move the meter away from the target to comfortably read or record the data.

To ensure safe and highly accurate readings, connect the grounding lead from the side ground snap of the device to an earth-grounding point. Zeroing the Sensor:

To ensure accuracy, the meter must be held at a distance of ( The oscillating chopper sensor at the top of

: The FMX002 model might be versatile in its applications, capable of being used in different settings or for various tasks, depending on the industry or specific use case.

Note: If the device falls outside the ±10% window during verification, do not attempt to adjust internal potentiometers manually. Send the unit to an authorized Simco service center for professional calibration. 5. Maintenance and Troubleshooting Sensor Care

To get the most accurate results from your Simco FMX-002, follow this standard operating procedure: 1. Grounding the Unit

: Ground the plate first to clear any charge, then hold the device in the ionized airflow. The range for this mode is typically 0 to ±200V. Maintenance and Troubleshooting Simco-Ion FMX-004 Tutorial Jun 5, 2014 SIMCO Japan - FMX002 Fieldmeter