Zte F689 Bridge Mode Exclusive Jun 2026

Enter the ISP username and password you gathered earlier.

To begin, you need to log into the ZTE F689's web-based configuration interface:

For tech-savvy users where the option is "hidden" rather than removed, you can sometimes force the menu to appear using browser inspection tools: Access the Admin Panel : Log in via the gateway IP (usually 192.168.1.1 Inspect Element WAN Connection

| Problem | Likely Cause | Fix | |---------|--------------|-----| | No internet after enabling bridge | Router not set to PPPoE/DHCP (depending on ISP) | Configure router’s WAN interface accordingly | | Cannot access ONT web interface | Management IP lost | Factory reset ONT or connect via untagged management VLAN | | Only LAN1 works | Exclusive bridge limited to one port | Use LAN1 to connect your router | | Wi-Fi still active | Not disabled automatically | Log in (if still possible) and disable, or ignore since it’s on different subnet | zte f689 bridge mode exclusive

Before altering your wide-area network (WAN) settings, gather the necessary materials and configuration credentials to ensure an uninterrupted transition.

Take a screenshot or write down the following configuration values: (e.g., PPPoE or IP) VLAN ID: (e.g., 10, 35, or 100) 802.1p Priority: (typically 0) Step 3: Configure the Exclusive Bridge Mode Connection

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Enter the ISP username and password you gathered earlier

Change the setting from to Bridge (or PPPoE_Bridge / IP_Bridge if available). Step 3.3: Configure Service Type and VLAN Ensure the Service Type remains set to INTERNET .

Look for the section at the bottom of the WAN configuration page.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. This link or copies made by others cannot be deleted

Check the box for (or whichever physical port you plan to connect to your third-party router). This tells the ZTE F689 to send the bridged data strictly through that specific port. Save your changes. Step 5: Disable Wi-Fi and DHCP

The ZTE DHCP server is off, leaving your PC without an IP address.

Reboot both devices. If that fails, double-check your PPPoE credentials or VLAN ID settings on the new router. Some ISPs tie your connection to the MAC address of the original router; you may need to use your new router's "MAC Clone" feature to mimic the ZTE F689's WAN MAC address.

Connect your computer directly to one of the LAN ports on the ZTE F689 using an Ethernet cable.