Harvey Hv3 Water Softener Installation Manual 'link'

The Harvey HV3 uses non-electric twin cylinders. Connecting the hoses properly ensures balanced, continuous operation. Step 1: Connect the Inbound and Outbound Hoses Apply plumbing washers to both ends of the flexible hoses.

Slide the flexible drain hose onto the appropriate connector on the valve head. Run the drain hose to a standpipe, utility sink, or floor drain. The drain outlet must have an to prevent backflow and comply with plumbing regulations. harvey hv3 water softener installation manual

: Connect a separate hose to the white spigot on the side of the cabinet. This must run downhill through an outside wall to a visible point. 3. Commissioning & First Use The Harvey HV3 uses non-electric twin cylinders

This article provides general guidance only. Harvey's official recommendation is to have the unit installed by qualified professionals. If you choose to self-install, you do so at your own risk. Slide the flexible drain hose onto the appropriate

Locate your main water stopcock and turn it off completely. This isolates the water supply to your property. Open a cold water tap downstairs to drain residual water from the pipes and relieve pressure in the system.

: Salt levels should be checked weekly to ensure you never run out. Running out of salt won't damage the system, but you will have hard water again until you refill. When refilling, simply add new block salt to the compartment—the water required to make brine will already be present from the initial fill.

Connect the from the port marked "OUT" to the plumbing line feeding the rest of the house.