Sony H3113 Lock Remove Ftf //top\\ Jun 2026
If you cannot remember the Google account previously synced to the device, flashing an FTF file will not bypass this block. You will need to recover your Google account credentials through Google's account recovery portal.
While continuing to hold the button, insert the USB cable into the phone.
While holding the Volume Down button, plug the USB cable into your phone (the other end should already be plugged into the PC).
Before starting the firmware flashing process, verify that you have gathered all necessary hardware and software components:
, which can also reset the device and remove locks, though it performs a full factory wipe. Effectiveness and Risks Success Rate: sony h3113 lock remove ftf
Once the device reboots after the flash, you will be prompted to log in with the original Google account credentials previously synced to the phone. Ensure you know this email address and password before proceeding. Step-by-Step Guide to Removing the Lock via FTF Flashing
Use an original USB Type-C cable to avoid data disconnection mid-process.
Most Android devices have a hidden recovery mode that allows you to perform a factory reset. For the Sony H3113, you can try turning off the phone, then holding the and Volume Up keys simultaneously. When the Sony logo appears, release the Power key but continue holding Volume Up to enter recovery mode. From there, you can navigate (using volume keys) to "Factory reset" and confirm (using the power button). However, on many modern Sony Xperia devices, this stock recovery mode is non-existent or very limited, and often still requires the user to enter the forgotten PIN/password before allowing a reset.
I understand you're looking for a guide on creating an FTF file to remove a lock (like a forgotten screen lock) from a Sony Xperia H3113. However, I must first clarify important legal and ethical points. If you cannot remember the Google account previously
Are you stuck on a or a standard screen lock?
Power off your Sony Xperia XA2 Plus completely. Press and hold the Volume Down button on your phone, and while holding it, connect the USB cable to your computer. The phone's LED light should turn green, indicating that it is now in Flashmode and ready to receive the new firmware.
In the Firmware Selector window, select from the left column.
Flashing firmware requires preparation to prevent bricking your device. Ensure you meet these requirements before proceeding. While holding the Volume Down button, plug the
Once you see the green LED, click the button in FlashTool. The flashing process will begin and typically takes 5-10 minutes. Do not disconnect the cable or interrupt the process, as this could brick your device. You will see a progress bar and log messages in the FlashTool console. A final message indicating "Flashing finished" or "Flashing succeeded" will confirm the process is complete.
Make sure you are holding the Volume Down key before plugging in the cable, and check that your USB cable supports data transfer, not just charging.
Download and install the following components on your computer:
