By leveraging these resources, you can unlock the full potential of ZKTECO Web 3.0 and optimize your access control and time attendance management processes.
Most ZKTeco devices come with a (often using port 80 or 443 ). If your network does not use the 192.168.1.x subnet, the device may be inaccessible. The default port for the webserver is typically 80 , although some models use 1443 or 5252 .
| Username | Password | Notes | | :--- | :--- | :--- | | | admin | The most common default for older and standard devices. | | admin | 123456 | Very common for newer firmware versions and Korean market devices. | | admin | 888888 | Common on specific Access Control panels. | | admin | 1234567890 | Occasionally used on specific biometric terminals. | | admin | password | Rare, but possible on some rebranded or updated firmware. |
A3: Yes. On many models (like the InBioPC series), you can connect via Wi-Fi to the device’s built-in hotspot (default SSID is the device serial number) and then access the web server interface from your phone’s browser.
Regularly check the device’s system logs for failed login attempts, unexpected configuration changes, or unknown user accounts. Many ZKTeco devices provide an or Audit Trail feature under the System Settings menu.
The you are running (e.g., ZKBioSecurity, BioTime, ZKAccess).
Understanding which platform you are using is vital, as the default credentials vary significantly between an older device's onboard server and the ZKBioSecurity 3.0 desktop software.
ZKTeco Web 3.0 interfaces often perform best on Microsoft Edge (with Internet Explorer mode enabled) or older versions of Chrome.
admin or 123456 (Leave blank if neither works) Default IP Address: 192.168.1.201 or 192.168.0.201 Default Web Port: 80 or 8081
Most ZKTeco hardware devices and web software variants share a standardized set of factory credentials. Try these combinations in order: Primary Default Combination admin Password: admin Secondary Default Combinations
If an administrator user already exists on the device, the web login requires that specific admin user's ID and password instead of the defaults.
Locate the user table, typically named user_sp or auth_user . Find the row where the username is admin .
