Zk-5kx Manual ((install)) ❲No Login❳

the U/I button twice (or wait 10 seconds) to save and exit to the main menu. B. Setting Output Current/Limit (CC Mode)

In the normal interface, long press the button for 2 seconds to enter the parameter setting menu.

Connect your power source here (e.g., a laptop power brick or battery). OUT+/OUT-: Connect your load or device here. 3. Basic Operations How to Set Voltage and Current

This article synthesizes the core sections of the ZK-5KX manual, clarifying complex parameters, wiring protocols, and diagnostic routines. Zk-5kx Manual

Thermal cutoff (Adjustment range: 80°C–110°C). Cannot be disabled. Modifying and Saving Advanced Parameters

Configure OAP (Over Capacity, 0-60Ah) and OHP (Timeout Protection, 0-100h).

Turn the clockwise to increase or counter-clockwise to decrease the voltage. the U/I button twice (or wait 10 seconds)

Long press the encoder knob for 3 seconds to lock the new calibration matrix into the system's non-volatile memory.

utilizes a highly streamlined physical interface comprising four heavy-duty screw terminals, two control buttons, a rotary encoder, and two LED status indicators. Terminal Connections zk-5kx_voltage-converter.pdf - eleneasy.com

To enter the deeper system configuration menus, the encoder knob for more than 2 seconds from the normal operating interface. Short press the SW button to scroll through the following system settings: Display Code Parameter Name Description / Options OPEN Default Output State Connect your power source here (e

: Provides a convenient, regulated 5V output for powering small devices like an Arduino or a Raspberry Pi project directly from the module.

With nothing connected to the output terminals, set the ZK-5KX output voltage to the exact floating charge target (e.g., 14.4V for a 12V Lead-Acid battery, or 4.2V for a single 18650 Li-ion cell).

Short press SW until the output voltage calibration screen appears. Turn the output ON. Connect your meter to the output terminals. Rotate the encoder until the display perfectly matches the meter. Short press SW to save.